Overview | Halo Energy Sword | Adafruit Learning System

NeoPixel Sword. In this project we’re making a 3D Printed Energy Sword from the Halo video game series. Inside the blades are NeoPixel LEDs which are connected to an Adafruit …

Code | Halo Energy Sword | Adafruit Learning System

Adafruit AVR Boards. Next, you’ll need to install the Adafruit AVR boards package from the Boards Manager. Open the Boards Manager and search for Adafruit AVR.This includes all of the boards from Adafruit and will make Arduino compatabile with them.

[PDF]

Halo Energy Sword – Adafruit Industries

Overview NeoPixel Sword In this project we’re making a 3D Printed Energy Sword from the Halo video game series. Inside the blades are NeoPixel LEDs which are connected to an Adafruit …

Circuit Diagram | Halo Energy Sword – Adafruit Industries

Lithium Battery Charger. Adafruit Feather 32u4 Bluefruit LE has a built-in USB battery charging circuit. Plug in a microUSB cable into the microUSB port on the Adafruit Feather 32u4 Bluefruit LE to recharge the lipo battery using a USB adapter from a wall outlet or your computer.

3D Printable Halo Energy Sword by Adafruit Industries

In this project we’re making a 3D Printed Energy Sword from the Halo video game series. Inside the blades are NeoPixel LEDs which are connected to an Adafruit Feather BLE 32u4 micro-controller. A 2000mAh lipo battery will provide several hours of energy and can be recharged over USB.The blade is 86cm (34in) tall and the whole sword weighs

3D Printing | Halo Energy Sword | Adafruit Learning System

The Energy Sword is split into twenty main pieces. The top and bottom end of the handle parts, the front and back of the main handle and the eight pieces of the blades. The blades are split into four main pieces for the front and back.

Power | Halo Energy Sword by Mattel NeoPixel Upgrade

In my energy sword, the pin with the green wire was ground, and the yellow was voltage – This is of course subject to change. The colored wires might be different in your energy sword. The pins, however, should be in the same positions.

Halo Energy Sword by adafruit – Thingiverse

In this project we’re making a 3D Printed Energy Sword from the Halo video game series. Inside the blades are NeoPixel LEDs which are connected to an Adafruit Feather BLE 32u4 micro-controller. A 2000mAh lipo battery will provide several hours of energy and can be recharged over USB.The blade is 86cm (34in) tall and the whole sword weighs